Available 24/7 ยท Selma & Bexar, Comal, Guadalupe

Air Duct Cleaning Selma, TX

We provide air duct cleaning in Selma, TX, within our service area from our San Antonio base, with return-duct maintenance cleaning starting at $99. Independently owned and operating since 2009, Green Air Duct Club has the same team clean, repair and replace ducts. Call (210) 790-3600 for booking, available 24/7.

Independently owned since 2009 Cleaning & repair from one team Subdivision and apartment access planning

Straightforward Pricing

What It Costs in Selma

You get a figure before work starts, and it does not move without your written approval.

Air Duct Cleaning

Starting at$99
  • Maintenance cleaning from the return duct
  • Free mildew inspection
  • Free dryer inspection
  • Reduces allergen circulation
Call (210) 790-3600

Dryer Vent Cleaning

Starting at$79
  • Full-length lint removal
  • Shorter drying cycles
  • Reduces fire risk
  • Lower electricity use
Call (210) 790-3600

Final pricing depends on vent count, air handler access and duct condition. Provide the property address, unit number and equipment access details so we can confirm coverage and the work involved before scheduling.

2009Serving Central Texas Since
24/7Booking Availability
5Service Clusters, One Company
Bexar, Comal, GuadalupeCounties Within City

Built For This Market

What Shapes Your Duct Cleaning Visit

Incorporated in 1964, the city grew along Interstate 35 and spans Bexar, Comal and Guadalupe counties. Its suburban development history makes the property's actual duct condition and access more useful for planning than assumptions about its age.

County Lines and City Permits

Municipal building permit guidance lists HVAC additions and replacements, fireplaces and commercial finish-outs among work requiring permits and inspections. The city also lists the 2021 International Mechanical and Energy Conservation codes among its adopted construction codes. These provisions matter when a duct inspection identifies work beyond debris removal. We distinguish the cleaning scope from any proposed alteration so the owner can review each separately. Before proceeding with replacement or installation, the applicable requirements need to be checked for the property and proposed work, rather than inferred from its county alone.

Subdivision Homes and Apartment Access

Chelsea Crossing and Forest Creek appear on the city's neighborhood list, which identifies ten residential subdivisions and three apartment complexes. That mix makes identifying the system serving the requested space part of planning the visit. We check the actual duct layout and accessible equipment rather than infer them from a subdivision name. In an apartment, access to the unit may not provide access to every part of its dryer exhaust route. We establish which portions can be reached and describe any limitations before agreeing on the cleaning scope.

Cibolo Creek and Moisture Checks

Public Works maintains municipal drainage and provides a storm-water hotline in this community that originated beside Cibolo Creek. Drainage concerns outside the building and moisture found inside the duct system need separate attention. Describe where dampness appears and whether it follows water entry so we can focus the inspection on the affected area. Active moisture or growth means we stop work and recommend a licensed mold assessor. Municipal drainage maintenance does not resolve an indoor moisture source. Removing accumulated debris also cannot substitute for correcting the condition that allows growth to recur.

Retail, Manufacturing and Warehouse Access

Recent commercial development includes retail, manufacturing and warehousing, with warehousing identified as the city's fastest-growing segment. Duct-cleaning plans for these properties need to account for the work happening around the system, not just the ducts themselves. We establish the equipment location, reachable work areas and operational restrictions before defining the cleaning scope. A loading area or occupied workspace may affect where equipment can be placed and which sections can be reached. For an active facility, we review those boundaries with the facility contact so the proposed work reflects the access actually available.

Dusty circular damper with blades inside a rectangular wall cavity surrounded by white textured drywall

Rental Access

Plan Access Before the Visit

Book with the unit number, owner authorization and access arrangements so we can define the work for the right system. Call (210) 790-3600.

Everything Under One Roof

Services Available in Selma

Brightly lit cylindrical pipe underwater with metal circular equipment visible beside it

Five service groups run out of one company, so a single visit can cover more than the ducts and a problem found in one system does not mean hiring a second contractor.

Air Duct Services

The full range, from inspection through to new installation, residential and commercial.

Dryer Vent Services

Lint collects along the whole vent run, not just at the machine, and long attic runs clog first.

Attic Insulation

Under-insulated attics force the system to fight heat gain through the whole cooling season.

Indoor Air Quality

Filtration and UV sized to the duct system it is going into, which does more for allergies than cleaning alone.

Chimney Services

A short fireplace season still leaves creosote in the flue, and caps degrade across the long off-season.

Commercial & Multi-Unit

Offices, retail, restaurants and apartment blocks, staged by zone and run outside customer hours.

How the Job Runs

Inspect, Isolate, Clean, Verify

Dark insulated air duct opening in drywall with mesh screen and dust buildup

Duct cleaning goes wrong in predictable ways: debris blown back into rooms, damage to registers and drywall, and no way for the customer to tell what was actually done. The sequence is built around those three risks.

  1. Inspection first

    We identify duct materials, locate the air handler, count supply registers and returns, and note what can be reached from the registers versus what needs another way in. This determines the method, not the other way round.

  2. Access and containment

    Registers come off carefully, surfaces around closet and attic equipment are protected, and the system is isolated so each trunk or branch is worked in a controlled order.

  3. Source removal under negative pressure

    Loosened debris is pulled toward collection instead of drifting into the room. Agitation tooling is matched to the duct type, with a Rotobrush on individual runs for deep cleaning.

  4. Returns before supplies

    The return side goes first so the blower is not pulling loosened material through the system. While we are there we check the filter slot and return grille for bypass gaps, which is one of the most common reasons a house gets dusty again quickly after a cleaning.

  5. Verification and documentation

    You get a vent count, a note on anything that could not be safely reached and why, and photographs.

Where We Stop

When Cleaning Is Not the Answer

Sometimes the crew opens a system and finds a problem cleaning will not solve: a disconnected flex run, torn duct insulation, damaged duct board, standing water at the condensate line, or an unsafe electrical condition near the air handler. Cleaning through any of that is malpractice.

Two things we do not do. If we find active moisture or suspect mould beyond surface dust, we stop, document it, and tell you to bring in a mould assessor. Duct cleaning is not a substitute for fixing the water source. We also do not sell fogging as a fix; if your goal is fewer allergens, whole-home filtration or a UV install does more than any spray.

For everything within our scope, being one company matters. A cleaning that uncovers a collapsed flex section does not mean starting over with a new contractor. Duct repair and replacement are handled by the same team that did the inspection, and you approve any change in scope first.

Areas We Serve

Selma and Bexar, Comal, Guadalupe

We include this community in our advertised service area, along with the nearby towns below. We confirm availability for your address and requested service when you contact us.

Before we dispatch

It helps to know the air handler location (attic, closet or garage), whether attic access is clear, how many supply registers and return grilles you have, and anything affecting entry: unit numbers, owner authorization, equipment access and loading-area restrictions.

Available 24/7

Book Air Duct Cleaning in Selma

Call any hour, email, or send the details through the enquiry form. Tell us the air handler location, your vent count, and any access limits, and we will confirm scope and scheduling.

Homeowners and property managers can call (210) 790-3600 to book with the property address, access details and the symptoms they want inspected.

Green Air Duct Club. Independently owned, San Antonio based, operating since 2009.

FAQs

Common Questions

What affects the cost in Selma

In Selma, return-duct maintenance cleaning starts at $99 and includes a free mildew inspection and free dryer inspection. Deep duct cleaning with a Rotobrush machine starts at $45 per duct and includes a free full-system inspection. Dryer-vent maintenance cleaning starts at $79. Call (210) 790-3600 to discuss the scope; the return-maintenance offer is not whole-home deep cleaning.

The total depends on the selected scope, duct count, material condition and access. Subdivision homes and apartment units need property-specific access planning. Repair or replacement is separate from cleaning, and any applicable permit requirements need review before alteration work begins. Use our contact form to send the address and service details.

How much does air duct cleaning cost in Selma?

Maintenance cleaning from the return duct starts at $99. Deep cleaning of individual ducts with a Rotobrush machine runs from $45 per duct. Dryer vent cleaning starts at $79. The final figure depends on your vent count, how the air handler is accessed, and the condition of the ducts, which is why we inspect and quote rather than pricing over the phone.

Does a newer home along the Interstate 35 corridor need duct cleaning?

Recent construction alone is not a reason to clean the ducts. We look for accumulated debris and assess material condition before recommending a scope. An air duct inspection provides written findings to help separate a cleaning need from damage requiring repair. Cleaning removes debris within the agreed scope; it will not repair a collapsed duct or prevent new dust from entering.

Can you plan dryer-vent cleaning for an apartment unit?

Apartment dryer-vent requests need a clear understanding of the exhaust route, including whether its termination is accessible. Our advertised cleaning scope runs from the dryer collar to the exterior cap, but we confirm limitations for the actual installation. We take residential and commercial requests, with address-level availability checked before scheduling. Cleaning the accessible portion alone should not be confused with completing the full route.

Is duct cleaning enough for a recurring odor near Cibolo Creek?

An odor alone does not establish that dirty ducts are the cause. During inspection, we check accessible duct surfaces for debris and material damage, then explain which findings cleaning can address. The local moisture section above covers conditions that stop cleaning work. Our guide to duct cleaning and air purifiers distinguishes debris removal from filtration; neither should be presented as a guaranteed cure for a recurring odor.

What happens if older duct materials are found in a subdivision home?

Older materials need assessment, not an automatic cleaning recommendation. We examine accessible ductwork and explain whether its condition supports cleaning or calls for a separate repair or replacement scope. The age of a subdivision does not establish when its ducts were installed or last replaced. We do not handle asbestos; if it is suspected, we stop work and direct you to a licensed abatement contractor.

Can you work outside business hours for a commercial property?

Yes. Commercial and multi-unit work is commonly staged by zone and run outside customer hours, so front-of-house stays usable while back-of-house is handled first. We are available 24/7, and after-hours or staged work is planned in writing before the first visit so you know the sequence and the noise windows.

Get Your Selma System Handled

One call covers ducts, dryer vents, insulation, air quality equipment and chimney. No handoffs, no second contractor, no waiting for business hours.

(210) 790-3600 Call Now Contact Us